Using Wi-Fyre with an existing conventional fire alarm system
The conventional fire alarm system is most commonly used in small properties where detailed information on device locations is not normally required and where zones are used for identification.
Using Wi-Fyre with an existing analogue addressable fire alarm system
Analogue addressable fire alarm systems differ from conventional fire alarm systems in many ways, principally by providing improved flexibility and control.
Heat Detection for Airport Terminal Applications
The airport terminal. A humming centre of travel: excited families going on holiday; business men and women; backpackers; people waiting to greet arrivals or see friends and family off on journeys.
Smoke Detection in High Ceiling Applications Using ASD
As a result designers and installers tend to use detection technologies such as beam detection and aspirating smoke detection (ASD) where smoke measurements over an area, rather than from a single location, are determined. Independent tests have shown that ASD has a far higher sensitivity to smoke than point detector technology, resulting in a superior ability to detect smoke that is diluted or distributed as it rises to higher levels.
Using ASD for Coincidence & Redundancy Detection
Commonly known as “double knock”. Coincidence detection relies on alarm signals across two zones or between two detectors to activate before any evacuation/alarm occurs. In this instance, depending on the ASD specification, a detector or each pipe inlet can be used as a zone/address. Look at the table below to see which detectors can be used as a single zone or multiple zones/address.
