Key Features

  • UL 521 approved and compliant with the EN54:22 draft standard
  • Self-restorable analogue type system with optional pre-alarm setting
  • Cable based sensing allows detection at the point of risk
  • Low installation, maintenance and repair costs
  • Reliable solution for hazardous areas

Overview

The analogue control module is designed for use with FyreLine Analogue Linear Heat Detection cables. The control module interfaces between a fire alarm control panel or addressable module and a single zone of Analogue Linear Heat Detection cable.

The control module monitors the resistance of specially doped polymers within the sensor cable which change as a function of temperature. An abnormal change in resistance along the detection cable triggers either a pre-alarm or alarm on the interface module. The unit is intended to be simple and straightforward to install. Commissioning of the controller can be done using a standard laptop computer or a built-in self-programming module.

The Analogue control module complies with the latest standards and is housed in an IP66 rated enclosure.

Approvals

The FyreLine Analogue Controller is fully approved by the Underwriters Laboratories (UL) and bears the CE mark to show that they comply with all the applicable Directives including the CPR, EMC and the Low Voltage Directive (LVD).

  • UL 521
    Heat detectors for fire protective signaling systems.

Tech Specs

Dimensions (W x H x D) 182mm x 180mm x 90mm (7 1/8” x 7 1/8” x 3 1/2”)
Enclosure Rating IP66 (IK08) polycarbonate with removable cover
Finish Light grey
Operating Temperature Range 0ºC – 50ºC
Supply Voltage 20 – 28Vdc
Humidity 0% to 90% RH
Current Consumption, Normal & Fault <70mA
Current Consumption, Pre-alarm OR Alarm <80mA
Current Consumption, Alarm (& Pre-alarm) <100mA
Current Consumption, Fault <70mA
Visual Indicators ALARM: Red
PRE-ALARM: Red
FAULT: Orange
POWER: Green
Relay OutputsALARM, PRE-ALARM (all Form C) 2A @ 30Vdc load rating – resistive 0.25A @ 250Vac load rating – resistive
Fault Output Opto-isolated Phototransistor Output Max 50V @ 20mA
Remote Reset Isolated input for resetting module remotely (20-28Vdc pulse for at least 5s)
Alarm/Pre-alarm Temperature Range 54ºC to 100ºC (129ºF to 212ºF)

Downloads

Buy

Analogue Programmable Interface c/w EOL Module

18-200
POA
Contact Us

Analogue Programmable Interface, PC Only c/w EOL Module

18-201
POA
Contact Us